--- title: "Adding sensors to a Central Management appliance using the CLI:" slug: "adding-sensors-to-a-central-management-appliance-using-the-cli" tags: ["Product Usage", "IVX Cloud", "Sec Ops and Analytics"] updated: 2026-09-04T14:05:43Z published: 2026-09-04T14:05:43Z canonical: "docs.trellix.com/adding-sensors-to-a-central-management-appliance-using-the-cli" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Adding sensors to a Central Management appliance using the CLI: Use the commands in this section to add appliances that will function as sensors to a Central Management appliance. 1. Log in to the Central Management CLI. 2. Go to CLI configuration mode: cm-hostname > **enable** cm-hostname # **configure terminal** 3. Add the appliance: cm-hostname (config) # **cmc appliance** **address** cm-hostname (config) # **cmc appliance** **auth password username** cm-hostname (config) # **cmc appliance** **auth password password** where: - appl ID is the name of the appliance. (The name is displayed in the show cmc appliances command output.) - IP address is the IPv4 or IPv6 address of the management interface on the appliance. - username is the username of a user account on the appliance with the admin role. - password is the password of the user specified by username. 4. Repeat the previous step for each additional appliance. 5. Check the connection status: cm-hostname (config) # **show cmc appliances** 6. Save your changes: cm-hostname (config) # **write memory** **Example** The following example adds the nx-1 and nx-2 appliances to the Central Management appliance. ``` cm-1 (config) # cmc appliance nx-1 address 172.17.74.50 cm-1 (config) # cmc appliance nx-1 auth password username admin cm-1 (config) # cmc appliance nx-1 auth password password admin123 cm-1 (config) # cmc appliance nx-2 address 10.13.65.14 cm-1 (config) # cmc appliance nx-2 auth password username admin cm-1 (config) # cmc appliance nx-2 auth password password admin123 cm-1 (config) # show cmc appliances Appliance nx-1:    Address:             172.17.74.50    Enabled:             yes    Connected:           yes (server-initiated)    Status check OK:     yes    Version compatible:  no Appliance nx-2:    Address:             10.13.65.14    Enabled:             yes    Connected:           yes (server-initiated)    Status check OK:     yes    Version compatible:  no ``` :