--- title: "AdTran NetVanta AOS configuration" slug: "adtran-netvanta-aos-configuration-1" tags: ["Reference", "Helix Enterprise", "Sec Ops and Analytics"] updated: 2026-09-09T09:59:13Z published: 2026-09-09T09:59:13Z canonical: "docs.trellix.com/adtran-netvanta-aos-configuration-1" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # AdTran NetVanta AOS configuration Follow these instructions to send logs from AdTran NetVanta AOS to the Comm Broker via syslog.. #### Prerequisites - AOS 12 or Higher - 1st Generation NetVanta 3200/3205 (1200860Lx and 1200870Lx) #### Using the Web interface Configuring logging via the Web Interface is supported in AOS firmware revisions 12 and higher. If your AOS device does not support AOS firmware revision 12, use the procedure in [Using the command line interface](/network-and-platform/docs/adtran-netvanta-aos-configuration-1#using-the-command-line-interface). 1. Enable logging: 1. Click **Logging** under Utilities in the left menu. 2. Select the **Event History** checkbox. 2. Enable syslog: 1. Click the **Syslog Forwarding** tab. 2. Select the **Syslog Forwarding** checkbox. 3. Configure syslog options: 1. Choose a Syslog Forwarding Priority Level. **Info (0)** is the most verbose and **fatal (5)** is the least verbose. For general information about interface state changes and firewall messages, choose **Notice (3)**. 2. Enter the Syslog Receiver IP Address. This is the IP Address of the Trellix Comm Broker Sender. 3. Choose a Logging Facility between **Local 0** and **Local 9**. The logging facility level is an arbitrary value that can be used in the Syslog Server software for filtering. 4. Click **Apply**. 4. Save the configuration: - Click **Save** in the upper-right corner. > [!WARNING] > Caution > > Not clicking **Save** will cause the router to lose your changes with the next reboot. #### Using the command line interface You can use the Command Line Interface (CLI) to configure syslog logging in all versions of AOS. 1. Access global configuration code: 1. Enter `enable` to enter privileged exec mode. You may be prompted for a password. If you do not know this password, see the “Password Recovery in AOS” guide. 2. Enter `configure terminal` to access global configuration mode. 2. Enter `event-history on` to enable event logging. 3. Enter `logging forwarding on` to enable syslog logging. 4. Configure syslog options: #### Example ```plaintext ! event-history on logging forwarding on logging facility local0 logging forwarding priority-level info logging forwarding receiver-ip 192.168.1.1 ! ``` 1. Enter `logging facility local0` to set the logging facility. The logging facility option is used by the syslog server for filtering. 2. Enter `logging forwarding receiver-ip <ip-address>` to set the IP address to which syslog entries should be forwarded (the Trellix Comm Broker Sender). For example, `logging forwarding receiver-ip 192.168.1.1.` 3. Enter `logging forwarding priority-level <priority-level>` to set the priority level. The priority level options are `error`, `fatal`, `warning`, `notice` and `info` in ascending order of verbosity (that is, `error` is the least verbose and `info` is the most verbose). For example, `logging forwarding priority-level notice`.