--- title: "AdTran NetVanta AOS configuration" slug: "adtran-netvanta-aos-configuration" tags: ["Reference", "Helix", "Sec Ops and Analytics"] updated: 2026-09-05T17:23:01Z published: 2026-09-05T17:23:01Z canonical: "docs.trellix.com/adtran-netvanta-aos-configuration" stale: true --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # AdTran NetVanta AOS configuration Follow these instructions to send logs from AdTran NetVanta AOS to the Comm Broker via syslog.. **Prerequisites** - AOS 12 or Higher - 1st Generation NetVanta 3200/3205 (1200860Lx and 1200870Lx) **Using the Web interface** Configuring logging via the Web Interface is supported in AOS firmware revisions 12 and higher. If your AOS device does not support AOS firmware revision 12, use the procedure in [Using the command line interface](/network-and-platform/docs/adtran-netvanta-aos-configuration#using-the-command-line-interface). 1. Enable logging: 1. Click **Logging** under Utilities in the left menu. 2. Select the **Event History** checkbox. 2. Enable syslog: 1. Click the **Syslog Forwarding** tab. 2. Select the **Syslog Forwarding** checkbox. 3. Configure syslog options: 1. Choose a Syslog Forwarding Priority Level. **Info (0)** is the most verbose and **fatal (5)** is the least verbose. For general information about interface state changes and firewall messages, choose **Notice (3)**. 2. Enter the Syslog Receiver IP Address. This is the IP Address of the Trellix Comm Broker Sender. 3. Choose a Logging Facility between **Local 0** and **Local 9**. The logging facility level is an arbitrary value that can be used in the Syslog Server software for filtering. 4. Click **Apply**. 4. Save the configuration: - Click **Save** in the upper-right corner. > [!WARNING] > Caution > > Not clicking **Save** will cause the router to lose your changes with the next reboot. #### Using the command line interface You can use the Command Line Interface (CLI) to configure syslog logging in all versions of AOS. 1. Access global configuration code: 1. Enter `enable` to enter privileged exec mode. You may be prompted for a password. If you do not know this password, see the “Password Recovery in AOS” guide. 2. Enter `configure terminal` to access global configuration mode. 2. Enter `event-history on` to enable event logging. 3. Enter `logging forwarding on` to enable syslog logging. 4. Configure syslog options: 1. Enter `logging facility local0` to set the logging facility. The logging facility option is used by the syslog server for filtering. 2. Enter `logging forwarding receiver-ip <ip-address>` to set the IP address to which syslog entries should be forwarded (the Trellix Comm Broker Sender). For example, `logging forwarding receiver-ip 192.168.1.1.` 3. Enter `logging forwarding priority-level <priority-level>` to set the priority level. The priority level options are `error`, `fatal`, `warning`, `notice` and `info` in ascending order of verbosity (that is, `error` is the least verbose and `info` is the most verbose). For example, `logging forwarding priority-level notice`. **Example** 1. ```plaintext ! event-history on logging forwarding on logging facility local0 logging forwarding priority-level info logging forwarding receiver-ip 192.168.1.1 ! ```