--- title: "Approach 2: Using new hardware" slug: "approach-2-using-new-hardware" tags: ["Install and Get Started", "IPS 10.1.10"] updated: 2026-09-23T09:34:39Z published: 2026-09-23T09:34:39Z canonical: "docs.trellix.com/approach-2-using-new-hardware" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Approach 2: Using new hardware ## Before you begin - It is assumed that you have a system installed with the required Windows Server 2016 flavor. - It is assumed that this system meets the other requirements discussed in [Reviewing the upgrade requirements](/network-and-platform/docs/upgrade-requirements-for-the-manager). - It is assumed that the 9.x Manager version meets the requirement to upgrade to 10.1. If not, first upgrade the Manager to the required 9.x version. ## Task 1. Back up the 9.x database. See [Backing up Trellix IPS data](/network-and-platform/docs/backing-up-trellix-ips-data-1). 2. Upgrade the Manager to the latest 10.1 version. See [MDR Manager upgrade](/network-and-platform/docs/mdr-manager-upgrade) or [standalone Manager upgrade](/network-and-platform/docs/standalone-manager-upgrade-on-windows-operating-system) according to your deployment. If Central Manager, see [MDR Central Manager upgrade](/network-and-platform/docs/mdr-central-manager-upgrade) or [Stand-alone Central Manager upgrade](/network-and-platform/docs/standalone-central-manager-upgrade). 3. Back up the 10.1 Manager database. 4. On the new Windows Server 2016 server, install the same version of 10.1 Manager as in step-2. 5. On the network, replace the existing 9.x Manager server with the new 10.1 Manager. Make sure that the IP address of the new Manager is the same as that of the existing one. If the IP address is different, the Sensors cannot communicate with the new Manager system. In that case, re-establish this communication from each Sensor. > [!NOTE] > Note > > Trellix recommends to shut down the 9.x Manager server before assigning the same IP address to the new 10.1 Manager. 6. Restore the 10.1 database backup from the old 9.x Manager on the new 10.1 Manager. For information about how to restore a database, see the latest Trellix Intrusion Prevention System Product Guide. 7. Log on to the new 10.1 Manager and go to **Manager** → **** → **Troubleshooting** → **Logs**. Check the **Faults** tab to make sure everything works fine. 8. Back up the 10.1 database of the Manager server. See [Performing a database backup](/network-and-platform/docs/perform-a-database-backup). > [!NOTE] > Note > > In case of MDR, complete this procedure fully for one Manager before you proceed to the next.