--- title: "Barracuda Next Generation Firewall configuration" slug: "barracuda-next-generation-firewall-configuration-1" tags: ["Reference", "Helix Enterprise", "Sec Ops and Analytics"] updated: 2026-09-05T14:07:16Z published: 2026-09-05T14:07:16Z canonical: "docs.trellix.com/barracuda-next-generation-firewall-configuration-1" stale: true --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Barracuda Next Generation Firewall configuration This section describes how to send logs from Barracuda Next Generation Firewall to the Comm Broker using syslog. This involves configuring the firewall to send syslog messages and enabling the firewall to stream log files to external syslog devices like the Barracuda NG Control Center or a third-party syslog server. To configure Barracuda NextGen Firewall to send syslog: > [!NOTE] > Note > > The box wizard can only be used on hardware units. If you are deploying a virtual F-Series Firewall, you must configure the time zone and change the password manually. 1. Log in to the Barracuda NextGen Firewall F-Series. 2. Launch NextGen Admin. 3. In the Log in window, select **Firewall**. 4. Enter the **Management IP**, **Username**, and **Password**. 5. Click **Sign In**. The Authentication Check window opens. 6. Click **Trust**. To enable the syslog service: 1. Select **Config** > **Full Config** > **Box** > **Infrastructure Services** to open the Syslog Streaming page. 2. Click **Lock/Unlock**. 3. Enable the Syslog service. 4. Enter the destination IP address (for the Trellix Comm Broker Sender) and port to which syslog should be sent. 5. Click **Send Changes**. 6. Click **Activate**.