--- title: "Basic configuration" slug: "basic-configuration-1" tags: ["Central Management System", "Install and Get Started"] updated: 2026-09-30T22:58:38Z published: 2026-09-30T22:58:42Z canonical: "docs.trellix.com/basic-configuration-1" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Basic configuration This section describes how to perform the basic configuration of a Central Management System cluster. There are various options: - **Single-interface**. The simplest configuration uses the management (ether1) interface as the default HA interface, because this interface was already defined during the initial configuration of each Central Management System appliance in the cluster. A different interface can be specified, but requires additional configuration. - **Dual-interface**. In addition to the default HA interface, this configuration uses a backup HA interface for redundancy. - **WAN or LAN**. If the two nodes are in different subnets (a WAN), static routes that carry the traffic between the nodes must be configured. If the nodes are in the same subnet (a LAN), this is not necessary. - **Disaster recovery**. In this configuration, the two nodes are typically geographically separate and the interfaces have relatively low bandwidth. Alert data replication can be disabled to reduce the amount of traffic. For details, see [Disaster recovery](/network-and-platform/docs/disaster-recovery-1) . For information about optional configuration settings, see [Optional Configuration Settings](/network-and-platform/docs/optional-configuration-settings-1) . ### Note For information about converting the nodes in a cluster to standard, non-HA Central Management System appliances, see [Converting to a standard (non-HA) Central Management System configuration](/network-and-platform/docs/converting-to-a-standard-non-ha-central-management-system-configuration-1) . :