--- title: "Cable the Sensors in a stack for high availability" slug: "cable-the-sensors-in-a-stack-for-high-availability-1" tags: ["Hardware", "IPS 11.1.x"] updated: 2026-09-17T09:43:41Z published: 2026-09-17T09:43:41Z canonical: "docs.trellix.com/cable-the-sensors-in-a-stack-for-high-availability-1" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Cable the Sensors in a stack for high availability This procedure describes how to cable Sensors in a stack for high availability. 1. Plug the QSFP28 Direct Attach Copper (DAC) cable into port **G1/1** or **G1/2** of the first Sensor in the primary stack. 2. Connect the other end of the cable into the corresponding port labeled **G1/1** or **G1/2** of the first Sensor in the secondary stack. 3. Repeat steps 1 and 2 for the other Sensors in the primary and secondary stack. ![GUID-82AD101C-A63D-4ADC-9487-B1030CA90F49-low.png](https://cdn.us.document360.io/0d453a50-e1da-4d4a-9409-fea7959614d8/Images/Documentation/uuid-b6f78fac-0f9b-fd7a-58e3-82ac23d2b4fd.png?sv=2026-02-06&spr=https&st=2026-11-20T12%3A20%3A49Z&se=2026-11-20T13%3A20%3A49Z&sr=c&sp=r&sig=3m1JsMckTpsUEdbRjTSDmdDm1z14IeRkKPFhnBD2f04%3D) 4. On the rear panel of each NS9500 Sensor, plug a RJ-45 cable in the Management port (labeled MGMT). 5. Plug the other end of the cable into the network device connected to your Manager server. 6. Create a failover pair using Manager's **Failover Pairs** page. > [!NOTE] > Note > > To connect the first Sensor in the primary stack with the first Sensor in the secondary stack, you can use either the QSFP28 module (2x100 G) module or the QSFP+ (4x40 G) module. The QSFP28 modules support the DAC cables for interconnect.