--- title: "Cable the Sensors in a stack" slug: "cable-the-sensors-in-a-stack" tags: ["Hardware", "IPS 11.1.x"] updated: 2026-09-17T11:10:21Z published: 2026-09-17T11:10:21Z canonical: "docs.trellix.com/cable-the-sensors-in-a-stack" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Cable the Sensors in a stack The NS9500 Sensor offers the solution of stacking multiple Sensors to achieve scalability. The individual Sensors in the stack are interconnected using an external stacking cable. The scalability is achieved by stacking multiple NS9500 appliances. This procedure describes how to cable Sensors in a stack. 1. Plug the QSFP28 Direct Attach Copper (DAC) cable into the port **G0/1** of the first Sensor. 2. Connect the other end of the cable into port labeled **G0/2** of the second Sensor. 3. In case of a 4 node stack, repeat steps **a** and **b** for the other Sensors in the stack. 4. To complete the stack, plug the QSFP28 Direct Attach Copper (DAC) cable into the port labeled **G0/2** of the first Sensor. 5. Connect the other end of the cable into port **G0/1** of the last Sensor. ![GUID-86A40A15-29E0-4D1C-9781-B01AEDBC20D5-low.png](https://cdn.us.document360.io/0d453a50-e1da-4d4a-9409-fea7959614d8/Images/Documentation/uuid-a90ddeb7-9032-35b5-f2a1-919eadc4e9ab(1).png?sv=2026-02-06&spr=https&st=2026-11-20T09%3A04%3A11Z&se=2026-11-20T10%3A04%3A11Z&sr=c&sp=r&sig=InoyXGcaBGZTceRCPoD0DqTFjPoJjHQQD2mBZqQXCX0%3D) For more information on cabling Sensors, refer to Trellix Intrusion Prevention System NS-series Sensor Product Guide. 6. On the rear panel of the NS9500 Sensor, plug a RJ-45 cable in the Management port (labeled MGMT). 7. Plug the other end of the cable into the network device connected to your Manager server.