--- title: "Cable the Sensors in a standalone stack" slug: "cable-the-sensors-in-a-standalone-stack-1" tags: ["Hardware", "IPS 11.1.x"] updated: 2026-09-17T09:43:41Z published: 2026-09-17T09:43:41Z canonical: "docs.trellix.com/cable-the-sensors-in-a-standalone-stack-1" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Cable the Sensors in a standalone stack This procedure describes how to cable Sensors in a stack. 1. Plug the QSFP28 Direct Attach Copper (DAC) cable into the port **G0/1** of the first Sensor. 2. Connect the other end of the cable into port labeled **G0/2** of the second Sensor. 3. In case of a 4 node stack, repeat steps **1** and **2** for the other Sensors in the stack. 4. To complete the stack, plug the QSFP28 Direct Attach Copper (DAC) cable into the port labeled **G0/2** of the first Sensor. 5. Connect the other end of the cable into port **G0/1** of the last Sensor. ![GUID-86A40A15-29E0-4D1C-9781-B01AEDBC20D5-low.png](https://cdn.us.document360.io/0d453a50-e1da-4d4a-9409-fea7959614d8/Images/Documentation/uuid-a90ddeb7-9032-35b5-f2a1-919eadc4e9ab.png?sv=2026-02-06&spr=https&st=2026-11-20T11%3A54%3A45Z&se=2026-11-20T12%3A54%3A45Z&sr=c&sp=r&sig=GYvWwjPXii7UjOqFGFOsqOUrYFUmJjU2xSjyFO6A3ic%3D) 6. On the rear panel of each NS9500 Sensor, plug a RJ-45 cable in the Management port (labeled MGMT). 7. Plug the other end of the cable into the network device connected to your Manager server. > [!NOTE] > Note > > In a NS9500 Sensor standalone stack, you can connect one Sensor to another Sensor only by using a QSFP28 module.