--- title: "Cable the Sensors in a standalone stack" slug: "cable-the-sensors-in-a-standalone-stack" tags: ["Hardware"] updated: 2026-09-17T10:17:59Z published: 2026-09-17T10:17:59Z canonical: "docs.trellix.com/cable-the-sensors-in-a-standalone-stack" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Cable the Sensors in a standalone stack This procedure describes how to cable Sensors in a stack. 1. Plug the QSFP28 Direct Attach Copper (DAC) cable into the port **G0/1** of the first Sensor. 2. Connect the other end of the cable into port labeled **G0/2** of the second Sensor. 3. To complete the stack, plug the QSFP28 Direct Attach Copper (DAC) cable into the port labeled **G0/2** of the first Sensor. 4. Connect the other end of the cable into port **G0/1** of the second Sensor. ![NS9600-cabling-the-sensors-in-a-standalone-stack_nonPFO.jpg](https://cdn.us.document360.io/0d453a50-e1da-4d4a-9409-fea7959614d8/Images/Documentation/uuid-c1022e70-aa5b-7373-6684-0ef4176f2f07.jpg?sv=2026-02-06&spr=https&st=2026-11-20T08%3A22%3A06Z&se=2026-11-20T09%3A22%3A06Z&sr=c&sp=r&sig=MbbEEbuHn6hdmZfrjn6UP%2FxJ3dEcVdZpmsu2vuKHmbk%3D) 5. On the rear panel of each NS9600 Sensor, plug a RJ-45 cable in the Management port (labeled MGMT). 6. Plug the other end of the cable into the network device connected to your Manager server. > [!NOTE] > Note > > In a NS9600 Sensor standalone stack, you must connect one Sensor to another Sensor only by using a QSFP28 module operating at 100 Gigabit.