--- title: "Changing the appliance health reporting frequency" slug: "changing-the-appliance-health-reporting-frequency" tags: ["Integration", "Helix", "Sec Ops and Analytics"] updated: 2026-09-02T19:14:07Z published: 2026-09-02T19:14:07Z canonical: "docs.trellix.com/changing-the-appliance-health-reporting-frequency" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Changing the appliance health reporting frequency Use the commands in this topic to change the frequency with which the appliance uploads Trellix Helix health status reports. Use the `no` form of the command to restore the default interval (five minutes). **To change the upload frequency:** 1. Log into the appliance CLI. 2. Go to CLI configuration mode: ``` hostname > enable hostname # configure terminal               ``` 3. Change the frequency: ``` hostname (config) # helix health-stats interval ``` 4. Verify your change: ``` hostname (config) # show helix health-stats status ``` **To restore the default frequency:** 1. Log into the appliance CLI. 2. Go to CLI configuration mode: ``` hostname > enable hostname # configure terminal               ``` 3. Restore the default frequency: ``` hostname (config) # no helix health-stats interval ``` 4. Verify your change: ``` hostname (config) # show helix health-stats status ``` **Example** The following example specifies that the ex-03 appliance should upload health status reports to Trellix Helix every 10 minutes. ``` ex-03 (config) # helix health-stats interval 10 ex-03 (config) # show helix health-stats status Helix health reporting:   Service:     Enabled              : yes     Path                 : fenet/helix/ingest/status     Interval             : 10 minutes   ... ```