This chapter contains CLI commands for preparing or configuring the Gateway Load Balancer.
clear cloud-gwlb status
This command clears HealthCheck counters.
Type the command in the CLI as shown in the Syntax below.
Syntax:
intruShell@Jason-611u-10.100.10.10> clear cloud-gwlb status
intruShell@Jason-611u-10.100.10.10> show cloud-gwlb status
Sample Output:
HealthCheck Source IP: 0.0.0.0
HealthCheck Port : 9001
HealthCheck Protocol : tcp
HealthCheck Connection Count : 0
HealthCheck Service Start Time : 01/01/1970 - 00:00:00 UTC
Last HealthCheck Received : 01/01/1970 - 00:00:00 UTC
Applicable to: Virtual IPS Sensors
set cloud-gwlb healthcheck <disable | enable>
This command is used to set the HealthCheck status. You can verify the status with show cloud-gwlb healthcheck status
Type the command in the CLI as shown in the Syntax below.
Syntax:
IntruDbg#> set cloud-gwlb healthcheck disable
Sample Output:
IntruDbg#> show cloud-gwlb healthcheck status
Cloud GWLB Healthcheck : disabled
Tip
Trellix recommends enabling the HealthCheck status after troubleshooting.
Applicable to: Virtual IPS Sensors
show cloud-gwlb healthcheck status
This command displays the status of HealthCheck.
Type the command in the CLI as shown in the Syntax below.
Syntax:
IntruDbg#> show cloud-gwlb healthcheck status
Sample Output:
Cloud GWLB Healthcheck : Enabled
Applicable to: Virtual IPS Sensors
show cloud-gwlb status
This command displays information about HealthCheck.
Type the command in the CLI as shown in the Syntax below.
Syntax:
intruShell@Jason-611u-10.10.10.108> show cloud-gwlb status
Sample Output:
HealthCheck Source IP : 168.63.129.16 HealthCheck Port : 9001 HealthCheck Protocol : tcp HealthCheck Connection Count : 136404 HealthCheck Service Start Time : 07/25/2024 - 12:37:34 UTC Last HealthCheck Received : 07/30/2024 - 06:25:27 UTC
Applicable to: Virtual IPS Sensors