--- title: "CLI commands for Gateway Load Balancer" slug: "cli-commands-for-gateway-load-balancer-1" tags: ["Product Usage", "vIPS 11.1x", "vIPS"] updated: 2026-09-11T20:53:15Z published: 2026-09-11T20:53:15Z canonical: "docs.trellix.com/cli-commands-for-gateway-load-balancer-1" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # CLI commands for Gateway Load Balancer This chapter contains CLI commands for preparing or configuring the Gateway Load Balancer. ### clear cloud-gwlb status This command clears HealthCheck counters. Type the command in the CLI as shown in the Syntax below. ****Syntax:**** `intruShell@Jason-611u-10.100.10.10> clear cloud-gwlb status` `intruShell@Jason-611u-10.100.10.10> show cloud-gwlb status` ****Sample Output:**** `HealthCheck Source IP: 0.0.0.0 ` `HealthCheck Port : 9001 ` `HealthCheck Protocol : tcp ` `HealthCheck Connection Count : 0 ` `HealthCheck Service Start Time : 01/01/1970 - 00:00:00 UTC ` `Last HealthCheck Received : 01/01/1970 - 00:00:00 UTC ` ****Applicable to:**** Virtual IPS Sensors ### set cloud-gwlb healthcheck This command is used to set the HealthCheck status. You can verify the status with `show cloud-gwlb healthcheck status` Type the command in the CLI as shown in the Syntax below. ****Syntax:**** `IntruDbg#> set cloud-gwlb healthcheck disable` ****Sample Output:**** `IntruDbg#> show cloud-gwlb healthcheck status` `Cloud GWLB Healthcheck : disabled` > [!TIP] > Tip > > Trellix recommends enabling the HealthCheck status after troubleshooting. ****Applicable to:**** Virtual IPS Sensors ### show cloud-gwlb healthcheck status This command displays the status of HealthCheck. Type the command in the CLI as shown in the Syntax below. ****Syntax:**** `IntruDbg#> show cloud-gwlb healthcheck status` ****Sample Output:**** `Cloud GWLB Healthcheck : Enabled` ****Applicable to:**** Virtual IPS Sensors ### show cloud-gwlb status This command displays information about HealthCheck. Type the command in the CLI as shown in the Syntax below. ****Syntax:**** `intruShell@Jason-611u-10.10.10.108> show cloud-gwlb status` ****Sample Output:**** ``` HealthCheck Source IP                 : 168.63.129.16 HealthCheck Port                      : 9001 HealthCheck Protocol                  : tcp HealthCheck Connection Count          : 136404 HealthCheck Service Start Time        : 07/25/2024 - 12:37:34 UTC Last HealthCheck Received             : 07/30/2024 - 06:25:27 UTC ``` ****Applicable to:**** Virtual IPS Sensors