Enables or disables the Communications Broker Sender (Comm Broker) module that sends and receives third-party syslog and JSON formatted logs to the Threat Analysis Platform (TAP) for analysis.
Syntax
[no] commbroker enable
Parameters
no
Use the no form of this command to disable the Comm Broker module.
Example
The following example enables the Comm Broker module.
hostname (config) # commbroker enable Enabling commbroker Changes might take a few seconds to take effect. Use the CLI show tapsender health to check the connection status.
The following example disables the Comm Broker module.
hostname (config) # no commbroker enable Disabling commbroker
User role
Admin or perator
Command mode
Config
Supported appliances
This command is supported on the following appliances running the specified releases or later:
Network Security: Release 7.9