--- title: "Configure 100G Active Fail-Open chassis parameters" slug: "configure-100g-active-fail-open-chassis-parameters" tags: ["Hardware", "IPS 11.1.x"] updated: 2026-08-19T18:44:09Z published: 2026-09-17T07:33:47Z canonical: "docs.trellix.com/configure-100g-active-fail-open-chassis-parameters" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Configure 100G Active Fail-Open chassis parameters You can access the command line interface through the console port (serial terminal emulator) and web-based management via a secure HTTPS connection on the management port (SSH remote shell emulator). **Steps:** 1. Ensure that the chassis power is turned on. 2. Using an RJ45 RS232 console cable, connect a PC that is running the HyperTerminal to the Active Fail-Open Kit chassis. 3. Launch the HyperTerminal and set the following communication parameters. - Baud rate: 115200 - Data bits: 8 - Parity: None - Stop bits: 1 - Flow Control: XON/XOFF 4. Click **OK**. The CLI banner and login prompt are displayed. > [!NOTE] > Note > > The default **Username** and **Password** are **Trellix00**. The password is configurable. 5. Type the following: 1. Enable 2. Configure 3. management eth-if ip x.x.x.x 4. management eth-if ip-mask y.y.y.y 5. management eth-if default-gateway z.z.z.z 6. write memory > [!NOTE] > Note > > Reboot of the system is not required. 6. To view the current network settings, use the following command: `show management configured` **Sample output:** `IS100G_AFO> show management configured` `Interface Configurations:` `MacAddr : 00:e0:ed:93:24:9f` `Port : up` `IPOrigin : static` `IPAddress : 10.41.83.134` `IPMask : 255.255.255.0` `Default-Gateway : 10.41.83.252` `DHCPSendName : on`