--- title: "Configure Active Fail-Open chassis parameters" slug: "configure-active-fail-open-chassis-parameters" tags: ["Hardware", "IPS 11.1.x"] updated: 2026-08-19T18:44:17Z published: 2026-09-17T07:33:47Z canonical: "docs.trellix.com/configure-active-fail-open-chassis-parameters" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Configure Active Fail-Open chassis parameters You can access the command line interface through the console port (serial terminal emulator) and web-based management via a secure HTTPS connection on the management port (SSH remote shell emulator). **Steps:** 1. Ensure that the chassis power is turned on. 2. Using an RJ45 RS232 console cable, connect a PC that is running the HyperTerminal to the Active Fail-Open Kit chassis. 3. Launch the HyperTerminal and set the following communication parameters. - Bits per second: 115200 - Data bits: 8 - Parity: None - Stop: 1 - Flow Control: None 4. Click **OK**. The CLI banner and login prompt are displayed. > [!NOTE] > Note > > The default **Username** and **Password** are **Trellix00**. Trellix recommends you change the default password after your first login. 5. Configure the following: 1. Set the IP address for the Active Fail-Open chassis using the `set_ip` command. 2. Set the Gateway and the Mask using the commands, `set_gateway` and `set_netmask` respectively. 3. Reboot the chassis. 6. To view the Switch configurations use the `get_params` command.