--- title: "Configure fail-open kit model 1" slug: "configure-fail-open-kit-model-1" tags: ["Product Usage", "IPS 10.1.10"] updated: 2026-09-06T12:28:25Z published: 2026-10-05T15:41:20Z canonical: "docs.trellix.com/configure-fail-open-kit-model-1" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Configure fail-open kit model 1 ## Before you begin For each fail-open configuration, you will need to make sure you have all these components. - Determine the IP address for the fail-open switch or, if you are deploying multiple switches, a range of IP addresses - Determine a network mask and the default gateway for the fail-open switch - 4 cables to connect the fail-open switch and the Sensor - (Optional) A DB-9 RS232 female-female cable to access the fail-open switch CLI - 2 SFPs, XFPs, or QSFPs for the fail-open switch and 2 SFPs, XFPs, or QSFPs for the Sensor - Cables for a copper fail-open switch - 2 CAT5e cables (1 cross-over, 1 straight-through) for network ports - 2 CAT5e cables (straight-through) for monitor ports - Cables for a fiber fail-open switch - 2 LC fiber cables for network ports - 2 LC fiber cables for monitor ports - 1 control cable if you are connecting a passive fail-open switch Broadly, these are the steps you will need to follow to set up a fail-open kit. ## Task 1. Install the fail-open switch. 2. (Optional) Configure bypass switch parameters. 3. (Optional) Configure notification by SNMP traps 4. Cable bypass switch to a Sensor using the appropriate cables. 5. Configure Sensor ports as inline fail-open. 6. (Optional) Use the Web Manager to configure the fail-open switch settings.