--- title: "Configure fail-open kits 6 thru 10" slug: "configure-fail-open-kits-6-thru-10-2" tags: ["Product Usage", "IPS 11.1.x"] updated: 2026-11-19T12:31:15Z published: 2026-11-19T12:31:15Z canonical: "docs.trellix.com/configure-fail-open-kits-6-thru-10-2" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Configure fail-open kits 6 thru 10 **Prerequisites:** For each fail-open configuration, you will need to make sure you have all these components. - Determine the IP address for the fail-open switch or, if you are deploying multiple switches, a range of IP addresses - Determine a network mask and the default gateway for the fail-open switch - 4 cables to connect the fail-open switch and the Sensor - An RJ-11 RS232 cable to access the fail-open switch CLI - 2 SFP, SFP+, or RJ-45 cables for NS3x00, NS5x00, NS7x00, NS9x00 Sensors - Cables for a copper fail-open switch - 2 CAT5e cables (1 cross-over, 1 straight-through) for network ports - 2 CAT5e cables (straight-through) for monitor ports - Cables for a fiber fail-open switch - 2 LC fiber cables for network ports - 2 LC fiber cables for monitor ports Broadly, these are the steps you will need to follow to set up a fail-open kit.