--- title: "Configure packet capture settings in port mode" slug: "configure-packet-capture-settings-in-port-mode-3" tags: ["Product Usage", "IPS 11.1.x"] updated: 2026-11-19T12:28:23Z published: 2026-11-19T12:28:23Z canonical: "docs.trellix.com/configure-packet-capture-settings-in-port-mode-3" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Configure packet capture settings in port mode To configure the packet capture settings: 1. For a standalone Sensor, select **Devices** → **** → **Devices** → **** → **Troubleshooting** → **Packet Capturing** → **Capture Now**. The **Capture Now** page appears. 2. From the **Send Captured Packets To** drop-down list, select **Monitoring (SPAN) Port**. > [!NOTE] > Note > > Configure packet capture settings in span port is not supported on a stack of NS9600 and NS9500 Sensors. 3. Type the **Capture Duration** in minutes. > [!NOTE] > Note > > Select the **Run until explicitly stopped** option to keep capturing for an indefinite period till you stop the capture. **Configure SPAN port for packet capture**![Configure SPAN port for packet capture](https://cdn.us.document360.io/0d453a50-e1da-4d4a-9409-fea7959614d8/Images/Documentation/uuid-1f3a5968-928e-0194-ce8a-a4378af187a6(3).png?sv=2026-02-06&spr=https&st=2026-11-20T08%3A36%3A18Z&se=2026-11-20T09%3A36%3A18Z&sr=c&sp=r&sig=XshebkzRtIhtLcPOtp3kPWC8qAru39blHVboqpCyyMc%3D) 4. Configure the **Capture Rules**. > [!NOTE] > Note > > In the **IP Version**, type of IP setting: > > - For **ALL** and **ARP** traffic, IP setting (**IPv4**) > - For **IP** traffic, IP setting (**IPv4**/**IPv6**) 5. Click **Save** to save the capture settings. > [!NOTE] > Note > > After saving the capture settings, you can observe the timestamp using the **Status** field in the **Capture Now** window; note that the status is available only after you start a packet capture session. 6. Click **Start**. > [!NOTE] > Note > > The monitoring port should be configured in the Filter Rule before starting the capture. The **Status** displays the total number of packets that are captured. 7. To stop the packet capture session, before the configured duration, click **Stop**. 8. Click **Cancel**. The Sensor stops the capture and deletes the captured file. > [!NOTE] > Note > > If file upload has started then it cannot be canceled.