--- title: "Configure response ports" slug: "configure-response-ports-2" tags: ["Product Usage", "IPS 11.1.x"] updated: 2026-11-19T12:30:59Z published: 2026-11-19T12:30:59Z canonical: "docs.trellix.com/configure-response-ports-2" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Configure response ports Utilizing device response ports enables your device to send preset responses (enabled in policy configuration), such as a TCP reset, as well as post-detection responses, such as firewall blocking of traffic, upon detection of malicious traffic. The device response ports are most commonly used with an external tap operating configuration. The other operating modes allow responses to be injected back through the interface ports. Since responses cannot be injected into a segment through an external tap, response port configuration is necessary. 1. Go to **Devices** → **** → **Devices** → **** → **Setup** → **Physical Ports**. 2. Click on the **Response Ports** tab. 3. Double-click on the row of the response port to be configured. The **Response Port Details** window is displayed. **Configure Response Port window**![Configure Response Port window](https://cdn.us.document360.io/0d453a50-e1da-4d4a-9409-fea7959614d8/Images/Documentation/uuid-1196338c-fbf1-4746-6216-fe1612697bc8(7).png?sv=2026-02-06&spr=https&st=2026-11-20T12%3A56%3A42Z&se=2026-11-20T13%3A56%3A42Z&sr=c&sp=r&sig=%2BNsq5y1g8OpbCAcB%2BnGLK0A0OfeHWmcNrgr6rplwcM4%3D) 4. Select a **Speed (Duplex)**. The following are the supported options for NS-series Sensor models. - NS-series: - **Auto-Negotiate** - **1 Gbps** - **10 Gbps** 5. Select the **State** as either **Enabled** (On) or **Disabled** (Off). For example, you need to disable the port if you connect a new wire, then enable it after re-connection. 6. Select the network component the response port connects to (**Connected To**): either a **Switch** or a **Router**. - If you select **Router**, in the **Virtual MAC Address** type the MAC address of the router to which you are connecting. The MAC address **cannot** be the broadcast address "ff:ff:ff:ff:ff:ff." 7. Click **Save** to save your port changes.