--- title: "Configure Sensor monitoring ports" slug: "configure-sensor-monitoring-ports-3" tags: ["Hardware", "IPS 11.1.x"] updated: 2026-09-17T07:33:43Z published: 2026-09-17T07:33:43Z canonical: "docs.trellix.com/configure-sensor-monitoring-ports-3" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Configure Sensor monitoring ports **Prerequisites**: - The Sensor must be set up with trust established with a Manager server. - The Sensor has a free port pair which can be deployed in in-line fail-open mode. - It is assumed that you have inserted the necessary transceiver modules into the Sensor if you have completed cabling the Sensor and fail-open switch. When you set up a Sensor for the first time, its ports are disabled by default. The Sensor ports must be manually configured for in-line fail-open operation. **Steps:** 1. In the Trellix IPS Manager, go to **Devices** → **** → **Devices** → **** → **Setup** → **Physical Ports**. 2. Double-click one of the configurable ports, say **G0/1**. A configuration panel appears on the right side of the window. 3. Click the **State** drop-down and select **Enabled**. You are asked whether you want to proceed since this configuration also impacts port **G0/2**. 4. Click **Yes** to proceed. This enables port G0/1-G0/2. 5. Select the **Auto Negotiate** checkbox and make sure the **Speed (Duplex)** is set to **1 Gbps (Full)**. 6. Click the **Mode** drop-down and select **In-line Fail-Open Passive**. 7. Click the **Placement** drop-down and select **Inside Network** or **Outside Network**, depending on how you want to configure your ports. Trellix recommends choosing **Gx/1** or **xA** as Inside Network and **Gx/2** or **xB** as the **Outside Network**. 8. Click the **Response Port** drop-down and select the port that you want to assign. For an in-line fail-open or in-line fail-closed setup, you can configure the same port to be the response port. ![GUID-96308C77-2FD9-4F3B-8D08-71DA8552A1EF-low.png](https://cdn.us.document360.io/0d453a50-e1da-4d4a-9409-fea7959614d8/Images/Documentation/uuid-d67f5260-f037-9dbd-ac2d-da503e5a5243.png?sv=2026-02-06&spr=https&st=2026-11-20T15%3A11%3A02Z&se=2026-11-20T16%3A11%3A02Z&sr=c&sp=r&sig=6d2AMwQrp1inRRdI%2B9Xr718MHhTO25w3I3xKvn8HOIk%3D) 9. Click **Save**. **Result:** The Sensor and fail-open switch are set up. When traffic passes through the ports, you notice the port link status changes to **Up** and turns green.