--- title: "Configure Sensor Monitoring Ports" slug: "configure-sensor-monitoring-ports" tags: ["Hardware", "IPS 11.1.x"] updated: 2026-09-17T07:33:43Z published: 2026-09-17T07:33:43Z canonical: "docs.trellix.com/configure-sensor-monitoring-ports" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Configure Sensor Monitoring Ports **Prerequisites:** - The Sensor must be set up with trust established with a Manager server. - The Sensor has a free port pair which can be deployed in in-line fail-open mode. - It is assumed that you have inserted the necessary transceiver modules into the Sensor if you have completed cabling the Sensor and fail-open switch. When you set up a Sensor for the first time, its ports are disabled by default. The Sensor ports must be manually configured for in-line fail-open operation. **Steps:** 1. In the Trellix IPS Manager, go to **Devices** → **** → **Devices** → **** → **Setup** → **Physical Ports**. 2. Double-click port one of the configurable ports, say **G2/1**. A configuration panel appears on the right side of the window. 3. Click the **State** drop-down and select **Enabled**. You are asked whether you want to proceed since this configuration will also impact port **G2/2**. 4. Click **Yes** to proceed. This enables port G2/1-G2/2. 5. Select the **Auto Negotiate** checkbox and make sure the **Speed (Duplex)** is set to **1 Gbps (Full)**. 6. Click the **Mode** drop-down and select **In-line Fail-Open – Active**. 7. Click the **Placement** drop-down and select **Inside Network** or **Outside Network**, depending on how you want to configure your ports. Trellix recommends choosing **Gx/1** or **xA** as the **Inside Network** and **Gx/2** or **xB** as the **Outside Network**. ![GUID-D430E98B-B0B5-497B-B31D-601FBB8C36EF-low.png](https://cdn.us.document360.io/0d453a50-e1da-4d4a-9409-fea7959614d8/Images/Documentation/uuid-e41486da-0390-d183-b49f-8faaf59c2e52.png?sv=2026-02-06&spr=https&st=2026-11-20T18%3A05%3A20Z&se=2026-11-20T19%3A05%3A20Z&sr=c&sp=r&sig=7yAqCZuCgrWoTFU%2FSNUZ3s7ynBK0gPWkoVEbCcUY3lE%3D) 8. Click **Save**. **Result:** The Sensor and fail-open switch are set up. When traffic passes through the ports, you will notice the port link status changes to **Up** and turns green.