Configure Simulated Blocking at the interface level

Click the Devices tab.

Select the domain from the Domain drop-down list.

In the left pane, click the Devices tab.

Select the device from the Device drop-down list.

Select Setup → Advanced → Simulated Blocking.

By default, Simulated Blocking is disabled for the entire device.

Simulated Blocking dialog

Select Simulated Blocking for inbound/outbound traffic.

Note

Simulated Blocking is not supported separately for the traffic directions. If one is configured (enabled/disabled), the other is also configured similarly.

From the State drop-down list, make a selection.

Click Save.

The device level settings override the interface level settings, that is, you cannot configure Simulated Blocking at the interface level if it is configured at the device level.