--- title: "Configure the Fail-Open Bypass Switch in tap mode" slug: "configure-the-fail-open-bypass-switch-in-tap-mode" tags: ["Hardware", "IPS 11.1.x"] updated: 2026-09-17T07:33:43Z published: 2026-09-17T07:33:43Z canonical: "docs.trellix.com/configure-the-fail-open-bypass-switch-in-tap-mode" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Configure the Fail-Open Bypass Switch in tap mode To configure the Bypass Switch in tap mode perform the following steps. 1. Type `set tap_mode` on the CLI command prompt. 2. Type **1** to set the tap mode **On** or 0 to set the tap mode **Off**. OR Log on to the web management interface and select **Segment A** on the left menu. Set the **Operation Mode** as **Tap** and click **Save**. ![GUID-E42C6FFB-5A8B-4E90-862E-FF8CA334B2FC-low.png](https://cdn.us.document360.io/0d453a50-e1da-4d4a-9409-fea7959614d8/Images/Documentation/uuid-61475459-4178-a104-f06a-2953b4a61b73.png?sv=2026-02-06&spr=https&st=2026-11-20T13%3A31%3A43Z&se=2026-11-20T14%3A31%3A43Z&sr=c&sp=r&sig=082TkXJyAEcwQIC95vVW78CLyEX6Nm4AdmSWnMHdegw%3D) > [!NOTE] > Note > > You can configure the Bypass Switch to tap mode only using CLI. Tap mode cannot be set using the Manager. To verify if the connection is in tap mode, navigate to **Device List** → **Sensor_Name** → **Physical Device** → **Port Settings**, and in the corresponding port pair **TAP** is displayed. In the **Operating Mode**, **In-line Fail-open Active (Port Pair)** is displayed.