--- title: "Configure the Manager Appliance" slug: "configure-the-manager-appliance" updated: 2026-11-19T12:43:24Z published: 2026-11-19T12:43:24Z canonical: "docs.trellix.com/configure-the-manager-appliance" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Configure the Manager Appliance After you have installed the Manager Appliance on the rack, connect the appliance to the power source and to your network. Connect a serial cable (null model cable DB9_F to DB9_F type), which is needed to configure the Manager Appliance. 1. Log in to the Manager shell using the following credentials: - Username: `admin` - Password: `admin` ### Note Trellix **strongly recommends**that you change the password immediately. For more information on the password control, see the section Configure password complexity settings in Trellix Intrusion Prevention System Product Guide. 2. To update network parameters, execute `configuration jump-start` command to update network parameters and open the Trellix configuration wizard. Next, enter the network parameters as shown below: | Parameters | Description | | --- | --- | | `Hostname` | Enter the hostname to be assigned to the Manager server. | | `Admin password` | Enter the password to be assigned to the Manager server. Next, confirm the password assigned to the Manager server. | | `Enable remote access for admin user` | Enter Yes or No. | | `Use DHCP on ether1 interface` | No. | | `Use zeroconf on ether1 interface` | No. | | `Primary IPv4 address and masklen` | Enter the primary IPv4 address and mask length. | | `Default gateway` | Enter the default gateway IP address | | `Primary DNS server` | Enter the primary DNS server IP address. | | `Domain name` | Enter the domain name. | | `Enable fenet service` | No. | | `Enable fenet license update service` | Enter Yes to enable the fenet license service and No to disable the service. | | `Sync appliance time with fenet` | Enter Yes or No. | | `Enable NTP` | Enter Yes to enable the NTP and No to disable the NTP. | | `Update licenses from fenet` | Enter Yes to update the fenet license service and No to disable the service. | | `Enable IPv6 on management interface` | Enter Yes to enable IPv6 address and No to disable the IPv6 address on the management interface. | | `Send a request to be managed by CMS` | Enter Yes or No. | After executing the commands, hit `enter` to save the changes and exit the configuration wizard. ### Tip The CLI `ipsmanager enable` allows you to enable the Manager service. You can disable the service by issuing `no ipsmanager enable` command. :