--- title: "Configuring a proxy connection using the CLI" slug: "configuring-a-proxy-connection-using-the-cli-1" updated: 2026-09-08T21:44:57Z published: 2026-09-08T21:44:57Z canonical: "docs.trellix.com/configuring-a-proxy-connection-using-the-cli-1" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Configuring a proxy connection using the CLI Use the commands in this section to configure a proxy connection using the CLI. ###### Prerequisites - An established connection between the File Protect appliance and the Internet. - Administrator or Operator access to the File Protect appliance. To configure a proxy configuration: 1. Enable the CLI configuration mode: ``` hostname > enable hostname # configure terminal ``` 2. Specify the FQDN IP Address: ``` hostname (config) # fmps proxy fqdn ``` 3. Specify the port number: ``` hostname (config) # fmps proxy port ``` 4. Specify the username: ``` hostname (config) # fmps proxy username ``` 5. Specify the password: ``` hostname (config) # fmps proxy password ``` 6. Verify the values: ``` hostname (config) # show fmps proxy ``` ###### Example This example sets the FQDN and port number for the proxy connection and displays the result. ``` hostname (config) # fmps proxy fqdn 1.2.3.4 hostname (config) # fmps proxy port 80 hostname (config) # show fmps proxy Proxy Config: Enabled  : no FQDN     : 1.2.3.4 Port     : 80 Username : Password : ******** ``` :