--- title: "Configuring a static IP address for the ether1 interface" slug: "configuring-a-static-ip-address-for-the-ether1-interface" tags: ["Endpoint Security (HX)", "Product Usage"] updated: 2026-09-09T22:45:38Z published: 2026-09-09T22:45:38Z canonical: "docs.trellix.com/configuring-a-static-ip-address-for-the-ether1-interface" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Configuring a static IP address for the ether1 interface This topic describes how to manually configure a static IP address for the ether1 (management) interface. ### Important If you do not follow this procedure, you will lose SSH access to the management interface. To restore access, you must stop and then restart the instance from the EC2 Management Console. ### Note Perform this procedure before you start the configuration jump-start wizard. If you already started the wizard, enter CTRL+C to exit it **before** you respond to the "Use DHCP on ether1 interface?" step. To configure a static IP address: 1. Go to CLI configuration mode: ``` hostname > enable hostname # configure terminal                     ``` 2. Configure the IP address and subnet mask: `hostname (config) # interface <interface name> ip address <ip address> /<mask>` ### Important Configure the same values you configured when you launched the instance on AWS. 3. Configure the default gateway: `hostname (config) # ip default-gateway <gateway IP>` 4. Save your changes: `hostname (config) # write memory` 5. Enter the configuration wizard: `hostname (config) # configuration jump-start` 6. Perform the initial configuration of the appliance. ### Important Enter **no** to the "Use DHCP on ether1 interface?" step. :