--- title: "Configuring a syslog server using the CLI" slug: "configuring-a-syslog-server-using-the-cli-1" tags: ["File Protect (FX)", "Product Usage"] updated: 2026-09-08T22:56:48Z published: 2026-09-08T22:56:48Z canonical: "docs.trellix.com/configuring-a-syslog-server-using-the-cli-1" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Configuring a syslog server using the CLI This topic describes how to use CLI commands to specify a syslog server for log messages on the File Protect appliance. For a full list of logging commands and the usage and parameters, see the *CLI Command Reference*. Prerequisites - Admin access To specify a syslog server: 1. Go to CLI configuration mode: ``` hostname > enable hostname # configure terminal ``` 2. To specify a syslog server to which logging messages are sent, use the `logging <serverAddress>` command, where `<serverAddress>` is the server IP address. For example: ``` hostname (config) # logging 10.10.20.62 ``` 3. Verify your changes: ``` hostname (config) # show logging Local logging level:                   notice   Override for class mgmt-back:       notice   Override for class mgmt-front:      notice ``` ``` Remote syslog default level:           notice Remote syslog servers:   10.10.20.62                         notice      protocol:                        udp      port:                            514 [ . . . ] ``` 4. Save your changes. ``` hostname (config) # write memory ``` :