--- title: "Configuring an Azure Blob scan using the CLI" slug: "configuring-an-azure-blob-scan-using-the-cli-1" updated: 2026-09-08T21:44:57Z published: 2026-09-08T21:44:57Z canonical: "docs.trellix.com/configuring-an-azure-blob-scan-using-the-cli-1" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Configuring an Azure Blob scan using the CLI Configure and start an Azure Blob listen scan using the CLI. ### Prerequisites - Administrator access to the File Protect appliance. - An Azure Blob storage has been created and configured. To configure a scan for Azure Blob storage: 1. Enable the CLI configuration mode: ``` hostname > enable hostname # configure terminal ``` 2. Create an Azure Blob scan. ``` hostname (config) # fmps scan create from share ``` FSTest is the Azure Blob storage on which the scan will run. The scan ID is displayed. ``` configured ``` 3. Save your changes. ``` hostname (config) # write memory ``` **To start a scan from an existing scan:** 1. Enable the CLI configuration mode: 2. ``` hostname > enable hostname # configure terminal ``` 3. Start an Azure Blob listen scan from an existing scan. ``` hostname (config) # fmps scan start listen ``` ** is the ID of the existing scan. 4. Save your changes. hostname (config) # **write memory** :