--- title: "Configuring autosupport for system event notifications using the CLI" slug: "configuring-autosupport-for-system-event-notifications-using-the-cli-1" updated: 2026-09-08T22:58:04Z published: 2026-09-08T22:58:04Z canonical: "docs.trellix.com/configuring-autosupport-for-system-event-notifications-using-the-cli-1" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Configuring autosupport for system event notifications using the CLI Use the commands in this section to configure autosupport for system event notifications. (See [Viewing system events](/docs/configuring-system-event-notifications-using-the-cli-4) for information about viewing a full list of events.) To configure autosupport: 1. Go to CLI configuration mode: ``` hostname > enable hostname # configure terminal ``` 2. Enable autosupport email notifications (disabled by default): ``` hostname (config) # email autosupport enable ``` 3. Display the current configuration for generating autosupport emails for system events: ``` hostname (config) # show email ``` 4. Specify each event for which autosupport email notifications should be sent: ``` hostname (config) # email autosupport event ``` 5. Configure the supplemental Certificate Authority (CA) certificates that are used to verify the server certificates. - To use only the built-in list: ``` hostname (config) # email autosupport ssl ca-list none ``` - To use the default supplemental CA certificate list: ``` hostname (config) # email autosupport ssl ca-list default-ca-list ``` 6. Configure a security type to use for autosupport email. - No TLS: ``` hostname (config) # email autosupport ssl mode none ``` - TLS: ``` hostname (config) # email autosupport ssl mode TLS ``` - TLS none: ``` hostname (config) # email autosupport ssl mode tls-none ``` 7. Verify the server certificates: ``` hostname (config) # email autosupport cert-verify ``` 8. Save your changes: ``` hostname (config) # write memory ``` :