--- title: "Configuring DTI credentials" slug: "configuring-dti-credentials-5" tags: ["Network Security (NX)"] updated: 2026-08-24T22:01:15Z published: 2026-08-24T22:01:15Z canonical: "docs.trellix.com/configuring-dti-credentials-5" stale: true --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Configuring DTI credentials Virtual appliances have appliance-specific DTI credentials that are generated from the appliance's activation code and that cannot be changed. Physical appliances have factory-configured DTI credentials that should not be changed. You should never change DTI credentials, except when you need to configure a custom DTI source in a Network Address Translation (NAT) deployment in which both of the following are true: - The Central Management System appliance is behind a NAT gateway. - The managed appliance uses the non-default dual-port address type for communication with the Central Management System appliance. You can also change DTI credentials when you need to configure a custom DTI source in a cache proxy deployment. Prerequisites - Admin access ##### Configuring DTI credentials using the CLI Use the commands in this topic to configure DTI credentials (username and password). To configure DTI credentials: 1. Go to CLI configuration mode: ``` hostname > enable hostname # configure terminal ``` 2. Specify the user and password: `hostname (config) # fenet dti source type <name> username <user> password <password>` The variables have the following values: - `<name>`—The name of the custom DTI source. - `<user>` and `<password>`—The new credentials. 3. Verify your changes: ``` hostname (config) # show fenet dti configuration ``` 4. Save your changes. ``` hostname (config) # write memory ```