--- title: "Configuring file analysis settings using the CLI" slug: "configuring-file-analysis-settings-using-the-cli-1" updated: 2026-09-08T21:45:37Z published: 2026-09-08T21:45:37Z canonical: "docs.trellix.com/configuring-file-analysis-settings-using-the-cli-1" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Configuring file analysis settings using the CLI Use the commands in this section to configure file analysis settings using the CLI. To configure file analysis settings: 1. Enable the CLI configuration mode: ``` hostname > enable hostname # configure terminal ``` 2. To specify the maximum file size: ``` hostname (config) # fmps file config maxsize MB ``` 3. To specify the scan delay: ``` hostname (config) # fmps file config scan_delay minutes ``` 4. To specify the WINS server: ``` hostname (config) # fmps file config wins_server ipAddress ``` 5. To specify the share timeout: ``` hostname (config) # fmps file config share-timeout seconds ``` 6. Verify the values: ``` hostname (config) # show fmps file config ``` 7. Save your changes: ``` hostname (config) # write memory ``` ### Example The following example changes the maximum file size to 200 MB and the share timeout to 350 seconds, and then shows the updated file analysis settings. ``` hostname (config) # fmps file config maxsize 200 hostname (config) # fmps file config share-timeout 350 hostname (config) # show fmps file config Max File Size (MB):        200 Analysis Timeout (sec):    240 Scan Delay:                3 min 0 sec Wins Server: Share Timeout (sec):       350 ``` :