--- title: "Configuring HTTP access to install software updates using the CLI" slug: "configuring-http-access-to-install-software-updates-using-the-cli-2" updated: 2026-10-01T08:08:23Z published: 2026-10-01T08:08:23Z canonical: "docs.trellix.com/configuring-http-access-to-install-software-updates-using-the-cli-2" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Configuring HTTP access to install software updates using the CLI Use the commands in this topic to configure HTTP access to install software updates from a USB device onto the appliance. By default, you can access only the contents locally in the `fireeye` directory for the first partition from a specified URL. ### Note The Central Management System appliance does not host guest images when it is operating in "inline" mode. Prerequisites - Admin access - Enable auto-mounting on the USB device to the attached appliance. For details about how to enable auto-mounting, see [Enabling or disabling auto-mounting on a USB device using the CLI](/network-and-platform/docs/enabling-or-disabling-auto-mounting-on-a-usb-device-using-the-cli) . To configure HTTP access to install software updates from a USB device: 1. Go to CLI configuration mode: ```plaintext hostname > enable ``` ```plaintext hostname # configure terminal ``` 2. Enable HTTP access on the loopback interface on the appliance: ```plaintext hostname (config) # media usb web-access enable local ``` Local web access is enabled by default. 3. Specify the top-level directory as the location to extract software updates on a USB device: ```plaintext hostname (config) # media usb web-access top-dir fireeye ``` This directory will be used as the URL to extract the software on the USB device. For example, if you specified the install directory as `fireeye/gi-13.0701`, the URL for the installation is ` http://localhost/media/usb1/fireeye/gi-13.0701`. 4. Verify that the USB device is mounted: ```plaintext hostname (config) # show media usb USB auto-mount configuration:  Enabled:             yes  Local web access:    yes  Top-level directory: fireeye USB auto-mount status:  Device mounted:      yes  Access URL:          N/A ``` 5. Download software updates using the specified URL as the location to install the updates. See [Installing guest images from a USB device using the CLI](/network-and-platform/docs/installing-guest-images-from-a-usb-device-using-the-cli-2) for a representative procedure.