--- title: "Configuring IPv6 addresses for the IPMI interface" slug: "configuring-ipv6-addresses-for-the-ipmi-interface" updated: 2026-08-25T21:18:25Z published: 2026-08-25T21:18:25Z canonical: "docs.trellix.com/configuring-ipv6-addresses-for-the-ipmi-interface" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Configuring IPv6 addresses for the IPMI interface ### Important You can configure IPv6 addresses for the IPMI interface only for CM 7500 and CM 9500 appliances. Use the instructions in this section to configure an IPv6 Address for the IPMI interface using the CLI. For information about using the IPMI interface, see [The Appliance IPMI Interface](/docs/the-central-management-system-appliance-ipmi-interface-1). Prerequisites - One end of an Ethernet cable is plugged in to the IPMI port, and the other end of the cable is plugged in to an administrative computer or terminal server - Upgrade IPMI firmware version to 2.37. For details, see [Updating IPMI and BIOS firmware](/docs/updating-ipmi-and-bios-firmware-4). To configure an IPv6 address for the IPMI interface using the CLI: 1. Go to CLI configuration mode. ``` hostname > enable hostname # configure terminal ``` 2. Configure the static IPv6 address for the IPMI interface: ``` hostname (config) # ipmi lan6 ipaddr prefix <1-128> ``` 3. To enable DHCP on your network: ``` hostname (config) # ipmi lan6 dhcp enable ``` 4. Save your changes: ``` hostname (config) # write memory ``` 5. Display the configuration. For example: ``` hostname (config) # show ipmi interface IPMI LAN Settings ---------------------------------------- Admin Shut Down         : no Shut Down               : (n/a) Set in Progress         : Set in Progress IP Address Source       : DHCP Address IPMI LAN6 Settings ---------------------------------------- Static ipv6 Address     : 2015:9:19:ffff::da7/64 Dhcp ipv6 Address       : 2015:9:19:ffff::da7/64 ``` :