--- title: "Configuring MDR with NAT" slug: "configuring-mdr-with-nat-2" tags: ["Product Usage", "IPS 11.1.x"] updated: 2026-11-19T12:28:23Z published: 2026-11-19T12:28:23Z canonical: "docs.trellix.com/configuring-mdr-with-nat-2" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Configuring MDR with NAT To set up MDR with NAT, consider the following scenarios: ### Scenario 1: Manager-Sensor communication with NAT and Manager-Manager communication without NAT Configure the public IP address (external reachable) in the **Peer Host IP address** field to establish Manager-Sensor communication. > [!NOTE] > Note > > To support multiple NIC cards, select the respective IP address in the **Sensor communication Interface**field during installation. For more information, refer to Trellix Intrusion Prevention System Installation Guide. Configure the **OOB Peer Manager IP** field with the local IP address of the peer Manager to reach the Manager without using NAT. If Manager is in a private network, enter the public IP address in the **Peer Host IP address** field of the Secondary Manager. ### Scenario 2: Manager-Sensor Communication with NAT and Manager-Manager communication with NAT Configure the public IP address (external reachable) in the **Peer Host IP address** field to establish Manager-Sensor communication. You need not configure **OOB Peer Manager IP** field as communication takes place using the **Peer Host IP Address** field. > [!NOTE] > Note > > In case the peer Manager uses different translated IP addresses, you can configure the public (external reachable) IP address in the **OOB Peer Manager IP** field.