--- title: "Configuring the minimum severity of messages sent to syslog servers using the CLI" slug: "configuring-minimum-severity-messages-sent-syslog-servers-cli" tags: ["File Protect (FX)", "Product Usage"] updated: 2026-09-08T23:58:50Z published: 2026-09-08T23:58:50Z canonical: "docs.trellix.com/configuring-minimum-severity-messages-sent-syslog-servers-cli" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Configuring the minimum severity of messages sent to syslog servers using the CLI This topic describes how to use CLI commands to specify the minimum severity level of log messages sent to syslog servers. For a full list of logging commands and the usage and parameters, see the *CLI Command Reference*. Prerequisites - Admin access To configure the minimum severity of log messages sent to syslog servers: 1. Go to CLI configuration mode: ``` hostname > enable hostname # configure terminal ``` 2. To specify the minimum severity level of messages sent to syslog servers, use the `logging trap <severity>` command, where `<severity> `is one of the following: - **none**—Disables logging. - **emerg**—System failure. - **alert**—Immediate action required. - **crit**—Critical condition. - **err**—Error condition. - **warning**—Warning condition. - **notice**—Normal but significant condition. - **info**—Informational message. - **debug**—Debug-level message. The following example specifies that all log messages of error level or higher severity are sent to the syslog server: ``` hostname (config) # logging trap err ``` 3. Verify your changes: ``` hostname (config) # show logging Local logging level:                   notice   Override for class mgmt-back:       notice   Override for class mgmt-front:      notice ``` ``` Remote syslog default level:           err Remote syslog servers:   10.10.20.62err      protocol:                        udp      port:                            514 [ . . . ] ``` 4. Save your changes. ``` hostname (config) # write memory ``` :