--- title: "Configuring SNMP default settings using the CLI" slug: "configuring-snmp-default-settings-using-the-cli-1" tags: ["Product Usage", "FX 10.x", "AX 10.x", "NX 10.x", "Customer", "Network Security"] updated: 2026-09-07T21:29:17Z published: 2026-09-07T21:29:17Z canonical: "docs.trellix.com/configuring-snmp-default-settings-using-the-cli-1" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Configuring SNMP default settings using the CLI Follow these steps to configure the default SNMP settings: ### Prerequisites - Admin or Operator access to the Malware Analysis appliance. **To set the default SNMP configuration:** 1. Enable the CLI configuration mode: ``` hostname > enable hostname # configure terminal ``` 2. Specify the SNMP version used for notifications: - To use SNMP version 1, enter: ``` hostname (config) # fenotify snmp trap-sink version 1 ``` - To use SNMP version 2c, enter: ``` hostname (config) # fenotify snmp trap-sink version 2c ``` 3. Specify the delivery frequency for SNMP notifications: > [!NOTE] > Note > > Trellix recommends using `per-event` notifications. For example, send a notification whenever an event is triggered, enter: ``` hostname (config) # fenotify snmp trap-sink prefer message delivery per-event ``` 4. Save the configuration: ``` hostname (config) # write memory ```