--- title: "Configuring the default single-interface LAN option using the wizard" slug: "configuring-the-default-single-interface-lan-option-using-the-wizard-1" tags: ["Central Management System", "Install and Get Started"] updated: 2026-08-21T19:17:36Z published: 2026-08-21T19:17:36Z canonical: "docs.trellix.com/configuring-the-default-single-interface-lan-option-using-the-wizard-1" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Configuring the default single-interface LAN option using the wizard Use the commands and configuration wizard instructions in this section to configure the basic settings for a single-interface Central Management System cluster in a LAN deployment that uses the default ether1 interface. Configure the primary node: 1. Enable the CLI configuration mode: ```plaintext node1-hostname > enable node1-hostname # configure terminal ``` 2. Start the configuration wizard: ```plaintext node1-hostname (config) # configuration jump-start ``` 3. Respond to the basic Central Management System configuration questions the wizard asks, as described in the *Central Management System Administration Guide*. 4. Configure Central Management HA? Enter **yes**. 5. CM HA uses ether1 as CM HA default interface. Do you want to change CM HA interfaces? Enter **no**. Configure this node as primary CM HA node? Enter **yes**. 6. Wait for all services to be in the "running" state: ```plaintext node1-hostname (config) # show ha status ``` Configure the secondary node: Enter **no**. 1. Enable the CLI configuration mode: ```plaintext node2-hostname > enable node2-hostname # configure terminal ``` 2. Start the configuration wizard: ```plaintext node2-hostname (config) # configuration jump-start ``` 3. Respond to the basic Central Management System configuration questions the wizard asks, as described in the *Central Management System Administration Guide*. 4. Respond to the cluster configuration questions the wizard asks, as described below. Configure CM HA? Enter **yes**. 5. CM HA uses ether1 as CM HA default interface. Do you want to change CM HA interfaces? 6. Configure this node as primary CM HA node? Enter **no**. 7. CM HA primary node IP address? Enter the IPv4 address of the primary node. 8. CM HA primary node admin account password? Enter the password for the primary node's remote admin user. 9. Confirm CM HA primary node admin account password? Re-enter the password for the primary node's remote admin user. ### Note You can perform a manual failover to test the cluster. Failing over manually using the CLI ### Examples The following example shows the wizard steps used to configure the primary node using the default single-interface option. ```plaintext ... Step 15: CM HA uses ether1 as CM HA default interface. Do you want to change CM HA interfaces? [yes] no Step 16: Configure this node as primary CM HA node? [no] yes ... ``` ```plaintext To change an answer, enter the step number to return to. ``` ```plaintext Otherwise hit to save changes and exit. ``` ```plaintext Choice: ``` ```plaintext Configuration changes saved. ... ``` The following example shows the wizard steps used to configure the secondary node using the default single-interface option. ```plaintext ... Step 13: CM HA uses ether1 as CM HA default interface. Do you want to change CM HA interfaces? [yes] no Step 14: Configure this node as primary node? [no] no Step 15: CM HA primary node IP address? 172.16.127.144 Step 16: CM HA primary node admin account password? ******** Step 17: Confirm CM HA primary node admin account password? ******** ... Initiated CM HA node joining Node joining has started Please check the status with CLI 'show ha configuration'. ... Starting CM HA engine Configuration changes saved. ... ``` :