--- title: "Configuring the File Protect appliance using the CLI" slug: "configuring-the-file-protect-appliance-using-the-cli" updated: 2026-09-08T21:44:57Z published: 2026-09-08T21:44:57Z canonical: "docs.trellix.com/configuring-the-file-protect-appliance-using-the-cli" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Configuring the File Protect appliance using the CLI The File Protect CLI provides commands for configuring the Trellix appliance or sensor. The CLI commands you can enter depend on the CLI command mode and the privileges granted by your role. ### Procedure To log in to the File Protect CLI remotely: 1. To connect using SSH, open a terminal program or an SSH client in the remote system. - From a terminal program: 1. Enter the `ssh username@ipAddress` command, where `ipAddress` is the IP address of the appliance or sensor. 2. When prompted, enter your password. - From an SSH client: 1. Enter the appliance or sensor IP address and make sure port 22 is specified. 2. When prompted, enter your username and password. 2. To connect over a terminal server, open a Telnet program in the remote system. The `hostname >` prompt is displayed after you are logged in. 1. Enter the address and port of the terminal server. 2. Enter your username. 3. When prompted, enter your password. :