--- title: "Configuring the IPMI interface" slug: "configuring-the-ipmi-interface-6" tags: ["Product Usage", "CMS 11.x", "EX 11.x", "FX 11.x", "AX 11.x", "NX 11.x", "IVX 11.x", "Customer", "Network Security"] updated: 2026-09-07T20:58:07Z published: 2026-09-07T20:58:07Z canonical: "docs.trellix.com/configuring-the-ipmi-interface-6" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Configuring the IPMI interface Use the commands in this section to configure the IPMI interface. For information about using the IPMI interface after it is configured, see [The AX IPMI interface.](/network-and-platform/docs/the-malware-analysis-appliance-ipmi-interface) **Prerequisites** - One end of an Ethernet cable is plugged in to the IPMI port, and the other end of the cable is plugged in to an administrative computer or terminal server ### Viewing the IPMI configuration This procedure describes how to use the CLI to view the IPMI configuration. **To view the IPMI configuration:** 1. Go to CLI enable mode: ``` hostname > enable ``` 2. Display the configuration. For example: ``` hostname (config) # show ipmi interface IPMI LAN Settings ---------------------------------------- Admin Shut Down         : no Shut Down               : no IP Address Source       : Static Address IP Address              : 192.168.42.27 Subnet Mask             : 0.0.0.0 Default Gateway IP      : 0.0.0.0 ``` ### Configuring the IPMI port This procedure describes how to use CLI commands to configure the IPMI interface. **To configure the IPMI port:** 1. If you want to configure a static IP address for the IPMI interface, do the following: 1. Go to CLI configuration mode. ``` hostname > enable hostname # configure terminal ``` 2. If DHCP was previously configured for IPMI, change to the static method: ``` hostname (config) # ipmi lan ipsrc static ``` 3. Configure the IP address for the IPMI interface: ``` hostname (config) # ipmi lan ipaddr ``` 4. Configure the netmask for the IPMI interface: ``` hostname (config) # ipmi lan netmask ``` 5. Configure the default gateway for the IPMI interface: ``` hostname (config) # ipmi lan defgw ``` 2. If you want to configure DHCP: 1. Make sure that DHCP is enabled on your network: ``` hostname (config) # show ip dhcp ``` 2. Enable DHCP: ``` hostname (config) # ipmi lan ipsrc dhcp ``` 3. The default username for logging in to the IPMI Web UI is ADMIN. Configure the password. The password must be a minimum of five characters, and a maximum of 16 characters. ``` hostname (config) # ipmi user set password ``` 4. Save your changes. ``` hostname (config) # write memory ``` **To revert to the default configuration:** 1. Go to CLI configuration mode: ``` hostname > enable hostname # configure terminal ``` 2. Revert to default configuration: ``` hostname (config) # ipmi lan ipsrc static ``` 3. Save your changes: ``` hostname (config) # write memory ``` > [!NOTE] > Note > > It is important to use the latest IPMI firmware available for your system. For details, see [IPMI and BIOS firmware updates](/network-and-platform/docs/ipmi-and-bios-firmware-updates-6).