--- title: "Configuring the IPMI interface" slug: "configuring-the-ipmi-interface-7" tags: ["Malware Analysis (AX)", "AX 10.x", "Product Usage"] updated: 2026-10-01T19:02:01Z published: 2026-10-01T19:02:01Z canonical: "docs.trellix.com/configuring-the-ipmi-interface-7" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Configuring the IPMI interface Use the commands in this section to configure the IPMI interface. Prerequisites - One end of an Ethernet cable is plugged in to the IPMI port, and the other end of the cable is plugged in to an administrative computer or terminal server ### Viewing the IPMI configuration This procedure describes how to use the CLI to view the IPMI configuration. To view the IPMI configuration: 1. Go to CLI enable mode: ```plaintext hostname > enable ``` 2. Display the configuration. For example: ```plaintext hostname (config) # show ipmi interface IPMI LAN Settings ---------------------------------------- Admin Shut Down         : no Shut Down               : no IP Address Source       : Static Address IP Address              : 192.168.42.27 Subnet Mask             : 0.0.0.0 Default Gateway IP      : 0.0.0.0 ``` ### Configuring the IPMI port This procedure describes how to use CLI commands to configure the IPMI interface. To configure the IPMI port: 1. If you want to configure a static IP address for the IPMI interface, do the following: 1. Go to CLI configuration mode. ```plaintext hostname > enable hostname # configure terminal ``` 2. If DHCP was previously configured for IPMI, change to the static method: ```plaintext hostname (config) # ipmi lan ipsrc static ``` 3. Configure the IP address for the IPMI interface: ```plaintext hostname (config) # ipmi lan ipaddr ``` 4. Configure the netmask for the IPMI interface: ```plaintext hostname (config) # ipmi lan netmask ``` 5. Configure the default gateway for the IPMI interface: ```plaintext hostname (config) # ipmi lan defgw ``` 2. If you want to configure DHCP: 1. Make sure that DHCP is enabled on your network: ```plaintext hostname (config) # show ip dhcp ``` 2. Enable DHCP: ```plaintext hostname (config) # ipmi lan ipsrc dhcp ``` 3. The default username for logging in to the IPMI Web UI is ADMIN. Configure the password. The password must be a minimum of five characters, and a maximum of 16 characters. ```plaintext hostname (config) # ipmi user set password ``` 4. Save your changes. ```plaintext hostname (config) # write memory ``` ##### To revert to the default configuration: 1. Go to CLI configuration mode: ```plaintext hostname > enable hostname # configure terminal ``` 2. Revert to default configuration: ```plaintext hostname (config) # ipmi lan ipsrc static ``` 3. Save your changes: ```plaintext hostname (config) # write memory ``` ### Note It is important to use the latest IPMI firmware available for your system. For details, see [IPMI and BIOS firmware updates](/network-and-platform/docs/ipmi-and-bios-firmware-updates-6).