Configuring the LCD password minimum length using the CLI

To configure the minimum password length for this appliance or sensor, use the aaa authentication password lcd length minimum command in CLI.

The minimum password length is set to 0 (no min length) by default.

If you want to set the minimum length of the LCD password, use the command

hostname (config) # aaa authentication password lcd length minimum <number>

where number is 0 by default.

Prerequisites

To configure password strength rules:

Go to CLI configuration mode:

hostname > enable 
hostname # configure terminal

Specify the minimum password length. Use the following command:
```
aaa authentication password lcd length minimum <number>
```

Verify your changes:

hostname (config) # show aaa authentication password