--- title: "Configuring the LCD password minimum length using the CLI" slug: "configuring-the-lcd-password-minimum-length-using-the-cli-1" tags: ["File Protect (FX)", "Malware Analysis (AX)", "IAM", "Email Security - Cloud", "Network Security (NX)", "Email Security — Server", "Central Management System", "Helix Enterprise", "Endpoint Security (HX)", "Product Usage", "Install and Get Started", "Helix", "Intelligent Virtual Execution "] updated: 2026-09-01T19:03:12Z published: 2026-09-01T19:03:12Z canonical: "docs.trellix.com/configuring-the-lcd-password-minimum-length-using-the-cli-1" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Configuring the LCD password minimum length using the CLI To configure the minimum password length for this appliance or sensor, use the `aaa authentication password lcd length minimum` command in CLI. ### Note The minimum password length is set to 0 (no min length) by default. If you want to set the minimum length of the LCD password, use the command hostname (config) # aaa authentication password lcd length minimum where number is 0 by default. Prerequisites - Admin access To configure password strength rules: 1. Go to CLI configuration mode: ``` hostname > enable hostname # configure terminal ``` 2. Specify the minimum password length. Use the following command: ``` aaa authentication password lcd length minimum ``` 3. Verify your changes: ``` hostname (config) # show aaa authentication password ``` 4. Save your changes: ``` hostname (config) # write memory ``` :