For Sensor failover, connect two NS3600 Sensors using the appropriate ethernet cables. These two sensors must run the same software version.
Refer to the following table before you configure a HA pair:
Sensor Model | Ports to connect the HA pair | Cable requirements for failover |
|---|---|---|
NS3600 | 5 | 2 10G SFP+ and 1 standard LC-LC cable |
Plug the cable into port 5 of the active NS3600 Sensor.
Connect the other end of the cable to port 5 of the standby NS3600 Sensor. Only port 5 is required for failover to function properly.