--- title: "Connect the cable for Sensor failover" slug: "connect-the-cable-for-sensor-failover-1" tags: ["Hardware"] updated: 2026-09-17T10:37:47Z published: 2026-09-17T10:37:47Z canonical: "docs.trellix.com/connect-the-cable-for-sensor-failover-1" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Connect the cable for Sensor failover For Sensor failover, connect two NS3600 Sensors using the appropriate ethernet cables. These two sensors must run the same software version. Refer to the following table before you configure a HA pair: | Sensor Model | Ports to connect the HA pair | Cable requirements for failover | | --- | --- | --- | | NS3600 | 5 | 2 10G SFP+ and 1 standard LC-LC cable | 1. Plug the cable into port 5 of the active NS3600 Sensor. 2. Connect the other end of the cable to port 5 of the standby NS3600 Sensor. Only port 5 is required for failover to function properly.