--- title: "Connect the cable for Sensor failover" slug: "connect-the-cable-for-sensor-failover-4" tags: ["Hardware", "IPS 11.1.x"] updated: 2026-09-17T09:43:41Z published: 2026-09-17T09:43:41Z canonical: "docs.trellix.com/connect-the-cable-for-sensor-failover-4" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Connect the cable for Sensor failover For Sensor failover, connect two NS7x00 Sensors using the standard LC-LC cables. These two Sensors must be running the same software version. Purchase two 10G SFP+ and use the standard cables. Failover cables are additional hardware required to support failover communication between two NS7x00 Sensors. > [!NOTE] > Note > > Trellix does not ship the transceiver modules and cables with the NS7x00 Sensors. Please purchase the same separately for failover setup. Refer to the following table before you configure a HA pair: | Sensor Model | Port to connect the HA pair | Cable requirements for failover | | --- | --- | --- | | NS7300/NS7200/NS7100 | G0/1 | 2 10G SFP+ and standard LC-LC cable | **Steps:** 1. Plug the cable appropriate for use with your SFP+ module into port G0/1 of the active NS7x00 Sensor. 2. Connect the other end of the cable with SFP+ into port G0/1 of the standby NS7x00 Sensor.