--- title: "Connect the cable for Sensor failover" slug: "connect-the-cable-for-sensor-failover-6" tags: ["Hardware"] updated: 2026-09-23T09:43:06Z published: 2026-09-23T09:43:06Z canonical: "docs.trellix.com/connect-the-cable-for-sensor-failover-6" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Connect the cable for Sensor failover For Sensor failover, connect two NS7600 Sensors using the standard LC-LC cables. These two Sensors must be running the same software version. You need to purchase the required number of 10G SFP+ transceivers and cables as listed in the table below before you configure an HA pair. These cables are additional hardware required to support failover communication between two NS7600 Sensors. > [!NOTE] > Note > > Trellix does not ship the transceiver modules and cables with the NS7600 Sensors. You need to purchase the same separately for the failover setup. | Sensor Model | Ports to connect the HA pair | Transceiver and cable requirements for failover | | --- | --- | --- | | NS7600 | G0/1 with 5Gbps license capacity | 2 10G SFP+ and 1 standard LC-LC cable | | G0/1 and G0/2 with 10Gbps and 15Gbps license capacity | 4 10G SFP+ and 2 standard LC-LC cables | | G1/1 with 20Gbps license capacity | 2 25G SFP28 and 1 standard LC-LC | 1. **For port G0/1 with 5Gbps license**: Plug the cable appropriate for use with your SFP+ module into port G0/1 of the active NS7600 Sensor. Connect the other end of the cable with SFP+ into port G0/1 of the standby NS7600 Sensor. 2. **For ports G0/1 and G0/2 with 10 Gbps and 15Gbps license**: Plug the cable appropriate for use with your SFP+ modules into ports G0/1 and G0/2 of the active NS7600 Sensor. Connect the other end of the cable with SFP+ into ports G0/1 and G0/2 of the standby NS7600 Sensor. 3. **For port G1/1 with 20Gbps license**: Plug the cable appropriate for use with your SFP28 module into port G1/1 of the active NS7600 Sensor. Connect the other end of the cable with SFP28 into port G1/1 of the standby NS7600 Sensor. > [!NOTE] > Note > > To use the G1/1 port with an SFP28 module at 25 Gbps, install the 8-port SFP28/SFP+/SFP 25/10/1 Gbps network interface module in the G1 slot. For more information, see [8-port SFP28/SFP+/SFP 25/10/1 Gigabit interface module](/network-and-platform/docs/8-port-sfp28-sfp-sfp-25-10-1-gigabit-interface-module-1).