--- title: "Connect the cable to the Console port" slug: "connect-the-cable-to-the-console-port-3" tags: ["Hardware", "IPS 11.1.x"] updated: 2026-09-17T09:43:45Z published: 2026-09-17T09:43:45Z canonical: "docs.trellix.com/connect-the-cable-to-the-console-port-3" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Connect the cable to the Console port The Console port on the NS7x00 Sensor is used for setup and configuration of the Sensor. **Steps:** 1. For console connections, plug the DB9 Console cable supplied by Trellix into the Console port on the Sensor. This port is labeled **Console** in the Sensor front panel. ![GUID-03E2B7A2-421A-4CFC-A2BB-94285A5F7211-low.png](https://cdn.us.document360.io/0d453a50-e1da-4d4a-9409-fea7959614d8/Images/Documentation/uuid-5d49e0b5-2d03-c671-678d-ab5832a27d15.png?sv=2026-02-06&spr=https&st=2026-11-20T10%3A16%3A41Z&se=2026-11-20T11%3A16%3A41Z&sr=c&sp=r&sig=nDDsEWiFapCi1rDbG6I2EmArZ1fsTfY8oxQw%2B8FBn9M%3D) 2. Connect the other end of the Console port cable directly to a COM port of the computer or terminal server you will use to configure the Sensor, for example, a computer running correctly configured Windows HyperTerminal software. You must connect directly to the console for initial configuration; you cannot configure the Sensor remotely. Terminal servers are provided for console access. Required settings for HyperTerminal are listed below: | Name | Setting | | --- | --- | | Baud rate | 115200 | | Number of bits | 8 | | Parity | None | | Stop bits | 1 | | Flow control | None | 3. Turn on the Sensor.