--- title: "Connect the cable to the Console port" slug: "connect-the-cable-to-the-console-port-8" tags: ["Hardware", "IPS 11.1.x"] updated: 2026-09-17T09:43:41Z published: 2026-09-17T09:43:41Z canonical: "docs.trellix.com/connect-the-cable-to-the-console-port-8" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Connect the cable to the Console port The Console port on the NS3500 Sensor is used for setup and configuration of the Sensor. **Steps:** 1. For console connections, plug in the RJ-45 cable supplied by Trellix into the Console port on the Sensor. This port is labeled **CONSOLE** in the Sensor front panel. ![GUID-2D7F8370-57FC-4051-846E-79112711885B-low.png](https://cdn.us.document360.io/0d453a50-e1da-4d4a-9409-fea7959614d8/Images/Documentation/uuid-b2eee15b-245e-7f85-831b-e6d9d51cdd8c.png?sv=2026-02-06&spr=https&st=2026-11-20T11%3A16%3A44Z&se=2026-11-20T12%3A16%3A44Z&sr=c&sp=r&sig=s1BPMfFb6LJVgFjnf1dS6mm5%2BD6nmEalXTaQIoEIoKM%3D) 2. Connect the other end of the Console port cable directly to a COM port of the computer or terminal server you will use to configure the Sensor, for example, a computer running correctly configured Windows HyperTerminal software. You must connect directly to the console for initial configuration; you cannot configure the Sensor remotely. Terminal servers are provided for console access. Required settings for HyperTerminal are listed below: | Name | Setting | | --- | --- | | Baud rate | 115200 | | Number of bits | 8 | | Parity | None | | Stop bits | 1 | | Flow control | None | 3. Turn on the Sensor.