--- title: "Connect the cable to the Console port" slug: "connect-the-cable-to-the-console-port" tags: ["Hardware"] updated: 2026-09-17T10:17:59Z published: 2026-09-17T10:17:59Z canonical: "docs.trellix.com/connect-the-cable-to-the-console-port" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Connect the cable to the Console port The Console port on the NS9600 Sensor is used for setup and configuration of the Sensor. 1. For console connections, plug the RJ45 straight cable with DB9-RJ45 adapter or DB9-DB9 null modem into the console port of the Sensor. This port is labeled **Console** in the Sensor back panel. 2. Connect the other end of the Console port cable directly to a COM port of the computer or terminal server you will use to configure the Sensor, for example, a computer running correctly configured Windows HyperTerminal software. You must connect directly to the console for initial configuration; you cannot configure the Sensor remotely. Terminal servers are required for console access. Required settings for HyperTerminal are listed below: | Name | Setting | | --- | --- | | Baud rate | 115200 | | Number of bits | 8 | | Parity | None | | Stop bits | 1 | | Flow control | None | 3. Turn on the Sensor.